Some important verifications…

clay-on-pist.jpg

I’ve put some children’s modeling clay on the top of the piston in TDC to measure:

-Squish area thickness (1,7mm)

cut-impression.jpg

-Valve distance to piston (minimum 1,5mm) ~5mm inlet, ~4mm exhaust

exh-valve-impr.jpg

Exhaust valve impression

in-valve-impr.jpg

Inlet valve…

Work in progress!

This entry was posted on October 11, 2007 at 8:02 pm and is filed under 3.3- Assembly. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

One Response to “Some important verifications…”

  1. Vasco Névoa Says:
    December 29, 2007 at 6:15 am

    Ok… so where’s the rest of it???? are you working on this stuff??….

Leave a Reply